Logistics · Instrument
Hypertube Propulsor
The end of a line that launches you into the air at the speed you had in the tube.
What it's for
The hypertube propulsor goes at the end of a line of
Hypertube, like a
Hypertube Entrance, but it is only a way out. A trip that reaches it does not slow down: its barrel shoots you into the air, along its axis, at the speed you had in the tube, and keeps that momentum up for 3 s. Then you come down with no fall damage. It draws 40 kW on standby and 250 kW right after a shot.
How it works
- Arrive on it through the tube: you come out in front of its mouth, launched along the barrel, at the speed of the trip.
- For 3 s, your forward speed does not drop; you rise then come down like anything that falls.
- The momentum stops sooner when you touch the ground, water or a wall, when you glide or when you sneak.
- Without power, it sets you down gently in front of its mouth, like an entrance: the trip slows down as it arrives.
What its panel says
- Sends the traveller off at the tube's speed.
- Right click: next angle. The wrench turns the mouth.
- Without power, a gentle exit like an entrance.
Placing and hookups
- 1 block
- Its mouth turns towards you when you place it; the wrench turns it a quarter turn.
- It needs two free blocks in front of the mouth, the one in front and the one above.
- Join a
Hypertube to it behind, on top, below or on a side, then connect it to the power grid. - Right click: the barrel goes to the next angle. It starts at 30 °, rises up to 90 ° (a vertical shot), then goes back to flat.
- Sneak + right click: its panel.
Its panel
- Its panel shows the launch angle, its state ("Ready", "No power", "No tube connected") and the power grid.
- An entrance's panel says when its line leads to a propulsor, and how far.
- Hover the "?" button in the title bar to read the machine's help, and the gauge of the State card for the network details.