Contents

Logistics · Instrument

Hypertube Entrance

Where a hypertube starts and ends: walk into its mouth to be drawn into the tube.

Hypertube Entrance, 3D render

What it's for

The hypertube entrance is a one-block gantry with a flared mouth, joined to a HypertubeHypertube. Walk into its mouth, or right-click it: you are drawn into the tube. It is also an exit: a trip that arrives at an entrance drops you in front of its mouth. It draws 30 kW on standby, and 350 kW as long as a trip that left from it is under way.

How it works

  • To leave: walk into the mouth facing the tube, or right-click the entrance.
  • The tube taken is the one touching it, looked for in this order: behind, above, below, left, right.
  • Without power it lets nobody leave, but it always receives arrivals.
  • On arrival, you come out in front of its mouth, gently pushed forward.
  • A trip already under way goes all the way, even if the power runs short.

Placing and hookups

  • 1 block
  • Its mouth turns towards you when you place it; the wrench turns it a quarter turn.
  • It needs two free blocks in front of the mouth, the one in front and the one above it: that is the exit space.
  • Join a HypertubeHypertube to it behind, on top, below or on one side, then connect it to the power grid.

Its panel

  • Its panel says where the tube leads: another entrance, a propulsor, a junction or an open end, and how far.
  • It also shows its state (“Ready”, “No power”, “No tube connected”) and the power grid.
  • Hover the "?" button in the title bar to read the machine's help, and the gauge of the State card for the network details.

Crafting

Unlocking

Tips

Common mistakes